Skip to content
Revival Vintage (USA)Revival Vintage (USA)
Vintage Zips Closeup


The History of the Zip

An early device known as an automatic continuous clothing closure, similar to the zipper was patented in 1851 by Elias Howe. It was a series of hook-like clasps with no slider, instead the two sides were joined together with string. Pulling the string meant the two sides were drawn together and the clasps interlocked.

Over the following 20 years improvements were made by inventors and engineers associated with a series of companies.

Initial versions were based on a system of hooks and eyes rather than interlocking teeth and tended to come apart easily. They relied on constant and even pressure from both sides of fabric. In 1891 there was a version which did have a type of slider but it was detached completely when not being used to open or close the zip.

Illustration Of An Early Zip

Difficulties in getting machinery for mass production also prevented early devices from reaching the market.

In 1906, Swedish-born Gideon Sundback joined the Automatic Hook and Eye Company in America and, through trial and error, in 1913 invented the first version of a zipper with interlocking teeth to prevent the pulling apart problem, called "Hookless Fastener No. 1." A year later, version 2 ironed out previous design faults and led the way to commercial success.

Revival Vintage Dress Zipper

The principle is that each tooth has a dimple punched into the bottom and a conical nib on top. Each nib on one side engages with the dimple of the tooth opposite on the other side. They are brought together by the two 'Y' channels of the slider. The teeth, of course, are clamped onto thick fabric so that it can easily be sewn to a garment.

The first types were made of a low-friction, long-wearing brass alloy. The name zipper was used in 1923. They became popular for children's and men's clothing in the 1920s/30s. In the early 1930s, the designer Elsa Schiaparelli featured zippers in her avant-garde gowns, promoting them to become more popular in women's clothing.

In 1934, Tadao Yoshida founded a company in Tokyo, Japan, which later changed its name to YKK (Yoshida Kogyo Kabushikikaisha) and went on to become the world's largest manufacturer of zippers and other fasteners.

By World War II, zippers had become widely used in Europe and North America and after the war spread to the rest of the world.

Clergy in the '20s and '30s scorned the zipper for allowing clothes to be taken off more quickly, therefore encouraging illicit sexual activity. Clothing with zippers was not seen as appropriate for women's wear by some and was not fully adopted until the late 1950s. Can you believe it?

Revival Mens Trouser Fastenings

Some zipper style tips to help you date your clothes:

  • Most men's pants continued to have button flies through the 1940s.
  • Coil-type nylon zippers were invented in 1940 but not in common use until the 1960s.
  • Side seam zippers were more common from the late 1930s to the 1960s.
  • Short center back zippers and sleeve zippers are mostly late 1930s/40s.
  • Center back zippers are seen occasionally on 1940s garments, but generally later in the 1950s/60s and nearly always from the 1970s on.

Vintage Clothing History Guide - Zips & Zippers

6 comments on Vintage Clothing History Guide - Zips & Zippers
  • Joann Maxwell
    Joann Maxwell September 02, 2026

    What years were the metal zippers by regal used. Found a mens or boys swim trunks with this and just wondering about the era. Thanks again, Mrs Maxwell

  • Alessandra
    Alessandra September 02, 2026

    Jonathan Cordova ,

    From what you described, and not knowing the suit manufacturer, I suggest you look up the YKK invisible Zipper. The teeth are hidden by an ingenious woven unit. This particular variety is very flexible and strong. Or, might have been the Reverse Coil Zipper, however, this variant seems less likely to because the teeth faces inward where the YKK’s teeth are concealed equally front & back.

    S.Garlic,

    The type of zippers you mentioned might be either the Coil Zipper or Chain Zipper.

    J. Maxwell,

    Regal produced zippers as you described c. 1930-60

  • Jonathan Cordova
    Jonathan Cordova September 02, 2026

    In the early 90s I purchased a vintage mens suit in Los Angeles, CA and the trousers had a type of covered zipper so the teeth were not visible. I never seen another one of those again.
    Not sure if it was called the Wortex Cover Zip but I cannot find any information on it. Very cool invention.

  • Kelly Hancock
    Kelly Hancock September 02, 2026

    I’ve always thought there weren’t zippers in 1920s clothes, but in watching The Show (1927) tonight, I noticed what appears to be a zipper running down the back of Renée Adorée’s dress towards the end of the show. Check it out and see what you think. It was my shock at seeing this that started the search that lead to your blog. I’m completely intrigued.

  • JOY Liotta -Horvath
    JOY Liotta -HorvathSeptember 02, 2026

    I have an older straw clutch that has a metal tooth zipper on it. The zipper pull on this bag has the letters "FLA"or “FLAS” stamped diagonally on the top side of the metal zipper pull. On the underside it spells “MADE IN ENGLAND”. Do you have any information about tis company? thanks for your time.
    Best,
    Joy

  • 1 2 Next »
Leave a comment

Your email address will not be published..

Cart

Your cart is currently empty.

Start Shopping

Select options